Cu-K型低温碳烟氧化催化剂的合成及表征

柴油机排放中碳烟的低温氧化是近年来研究的热点.通过原位合成法制备Cu2K/Al2O3和CuK／Al2O3两种碳烟氧化催化剂,并采用低温氮吸附/脱附实验、X射线衍射、X射线光电子能谱、程序升温氧化对其结构进行系统表征,并用U碳模拟柴油机碳烟,研究其催化活性,评测其对柴油机排气中碳烟颗粒的净化效果.研究表明,Cu2K/Al...     

基于遥感尾气监测的柴油车气态污染物排放因子计算方法研究

采用遥感尾气测试系统实测了柴油车在实际道路工况下的CO、HC和NO排放特征,修正了排放因子的计算方法,并与车载排放测试系统（PEMS）实测结果进行了验证,获得了实测车辆的CO、HC和NO排放因子.测试结果显示,在各种遥感监测的工况下柴油车尾气中均含有较高浓度的氧气,未考虑氧气影响的燃烧方程反演获得的各污染物体积浓度计算值与PEMS实测值的偏差较大,且氧气浓度越大,偏差越大.经过氧气修正的燃烧方程反演计算的尾气浓度与PEMS实测值吻合度大幅提升,适用于实际工况下遥感检测车辆尾气的反演计算.修正算法得到CO、HC和NO的排放因子离散性较小,精确度较高,可以为量化柴油车尾气排放贡献提供科学依据.     

DOC+CDPF对国III重型柴油货车实际道路排放的影响

利用便携式车载排放测试系统（PEMS）对2辆加装氧化催化转化器（DOC）和催化型柴油颗粒捕集器（CDPF）与否的国III重型柴油货车进行实际道路排放测试.结果表明,2辆改造重型柴油车的CO、THC、固态颗粒物粒数（SPN）和黑碳（BC）实际道路排放因子分别为（1.31±0.37）g/（kW×h）、（0.20±0.03） g/（kW×h）、（7.13×10¹⁰±5.27×10¹⁰）个/（kW×h）和（0.69±0.06）mg/（kW×h）,相对于原始排放（拆除DOC+CDPF）分别降低52.48%、55.69%、99.91%和99.22%.从低速、中速到高速,CO和THC减排比例呈现上升趋势,然而运行工况对SPN和BC减排比例则无显著影响.加装DOC+CDPF会导致NO₂在NO_x中的占比升高,且从低速、中速到高速涨幅依次增大,但对NO_x无明显减排效益,其排放因子为9.53~9.83g/（kW×h）,远高于实验室排放限值.     

Ultrafine particle emission characteristics of diesel engine by on-board and test bench measurement

This study investigated the emission characteristics of ultrafine particles based on test bench and on-board measurements. The bench test results showed the ultrafine particle number concentration of the diesel engine to be in the range of (0.56-8.35) × 10⁸ cm^-3. The on-board measurement results illustrated that the ultrafine particles were strongly correlated with changes in real-world driving cycles. The particle number concentration was down to 2.0 × 10⁶ cm^-3 and 2.7 × 10⁷ cm^-3 under decelerating and idling operations and as high as 5.0 × 10⁸ cm^-3 under accelerating operation. It was also indicated that the particle number measured by the two methods increased with the growth of engine load at each engine speed in both cases. The particle number presented a "U" shaped distribution with changing speed at high engine load conditions, which implies that the particle number will reach its lowest level at medium engine speeds. The particle sizes of both measurements showed single mode distributions. The peak of particle size was located at about 50-80 nm in the accumulation mode particle range. Nucleation mode particles will significantly increase at low engine load operations like idling and decelerating caused by the high concentration of unburned organic compounds.     

pH-dependent leaching behaviour and other performance properties of cement-treated mixed contaminated soil

Portland cement has been widely used for stabilisation/solidification (S/S) treatment of contaminated soils. However, there is a dearth of literature on pH-dependent leaching of contaminants from cement-treated soils. This study investigates the leachability of Cu, Pb, Ni, Zn and total petroleum hydrocarbons (TPH) from a mixed contaminated soil. A sandy soil was spiked with 3000 mg/kg each of Cd, Cu, Pb, Ni and Zn, and 10,000 mg/kg of diesel, and treated with ordinary Portland cement (CEM I). Four different binder dosages, 5%, 10%, 15% and 20% (m/m) and different water contents ranging from 13%-19% dry weight were used in order to find a safe operating envelope for the treatment process. The pH-dependent leaching behaviour of the treated soil was monitored over an 84-day period using a 3-point acid neutralisation capacity (ANC) test. The monolithic leaching test was also conducted. Geotechnical properties such as unconfined compressive strength (UCS), hydraulic conductivity and porosity were assessed over time. The treated soils recorded lower leachate concentrations of Ni and Zn compared to the untreated soil at the same pH depending on binder dosage. The binder had problems with Pb stabilisation and TPH leachability was independent of pH and binder dosage. The hydraulic conductivity of the mixes was generally of the order, 10^-8 m/sec, while the porosity ranged from 26%-44%. The results of selected performance properties are compared with regulatory limits and the range of operating variables that lead to acceptable performance described.     

LNAPL在砂质含水层中动态迁移的电阻率法监测试验研究

在海滨潮间带采集细砂,通过室内柴油泄漏模拟试验,利用自制电阻率监测系统对轻非水相液体在砂土-地下水系统垂向渗透过程进行电阻率变化动态监测;通过配制不同含油率砂土测定其静态电阻率变化规律,探讨电阻率变化的影响因素;最后取样分析测定污染含水介质稳定后含水率及含油率,对监测结果有效性进行了验证;并利用显微成像法对污染砂土进行了微观形态分析.结果表明,柴油污染砂土微观形态上胶结现象明显;柴油渗透海滨砂土过程电阻率大小同含水饱和度,比电阻率和含油饱和度之间存在良好的相关性,均可用Archie公式拟合,n值分别为2.36和0.15;通过电阻率测定可以有效估算柴油透镜体厚度;电阻率随深度的变化可以反映含油率和含水率的垂向分布.本研究为轻质油品储罐或者海上油品输运过程泄露造成的海滨砂土地下污染扩散过程监测及机制研究提供了一种有效的方法,也可为其他典型石油泄漏污染场地的电阻率法探测或监测提供参考.     

Feasibility analysis of renewable hybrid energy supply options for Masirah Island

In this paper, the assessment and modelling of alternative renewable energy systems for Masirah Island is considered. The hybrid system that is simulated comprises various combinations of wind turbines and/or photovoltaic (PV) supplemented with diesel generators and short-term battery storage. It was found from the analysis that the PV–wind–diesel hybrid system, with battery unit, has the lowest cost values as compared to solar-only or wind–diesel hybrid systems. Furthermore, the study illustrates that for a given hybrid system the presence of battery storage will reduce diesel consumption. The decrease in carbon emission, the percentage of fuel savings, the cost of energy production and the effect of wind and PV penetration are also addressed in this paper. The PV–wind–diesel hybrid option is techno-economically viable for the electrification of the Masirah Island.     

Effects of EGR,swirl augmentation techniques on combustion of biodiesel/ethanol and their blends in a diesel engine

The diminishing resources and continuously increasing cost of petroleum in association with their alarming pollution levels from diesel engines have caused an interest in finding alternative fuels to diesel which are renewable and sustainable. Emission control and engine efficiency are two most important parameters in current engine design. The impending introduction of emission standards such as Euro IV and Euro V is forcing the research towards developing new technologies for combating engine emissions. The classification of Euro IV and V norms is applicable to heavy-duty engines in Europe, where as Euro 5 is applicable to light-duty engines. This paper presents the effects of exhaust gas recirculation (EGR), swirl augmentation techniques and ethanol addition on the combustion of Honge oil methyl ester (HOME) and its blends with ethanol in a diesel engine. From the experimental work conducted, it is found that the combustion of HOME plus up to 15% ethanol blend in a diesel engine operated with optimised parameters of injection timing 23° Before Top Dead Centre and compression ratio 17.5 results in acceptable combustion emissions and improved brake thermal efficiency (BTE). The addition of ethanol increased BTE with reduced hydrocarbons (HCs), CO and smoke emissions. However, NO _x emissions increased dramatically. Use of appropriate EGR reduces NO _x to acceptable levels. The implementation of swirl augmentation techniques further resulted in increased BTE and considerable reduction in tail pipe emissions such as smoke, HCs, CO and NO _x . The effect of swirl by providing grooves on the piston was taken into consideration to find the overall biodiesel engine performance, which gives scope for further studies.     

Intelligent power supply management of an autonomous hybrid energy generator

ABSTRACT

This work deals with the optimization of an hybrid energy system used to supply an isolated site. The proposed system combines a wind turbine, a photovoltaic panel, a diesel generator and a battery bank to electrify atypical home. An energy cost-effectiveness approach is adopted in accordance with meteorological data, time profile of energy consumption, and the cost of different alternative systems. A variety of performances is obtained through simulations within the Homer Pro environment. The selection of an optimal combination is based on the maximum integration of renewable energy in the suggested system with a minimum of gas emission. According to the obtained results, the overall cost of the selected installation is about 72,900 €, with 0.415€ the unit cost of a kWh electric energy provided with a contribution of renewable energy of around 86%. Simulations show a technical and financial benefits of the different configurations obtained to supply the target site. To control the proposed hybrid energy system, a supervision algorithm is developed and implemented on TMS320F28027 DSP platform. The proposed energy system aims to take advantages of renewable energy sources and shift to conventional sources only when necessary in order to ensure source autonomy and service continuity.     

生物通风技术修复柴油污染土壤的土柱模拟实验

生物通风技术是将土壤气相抽提和生物降解结合起来的原位强迫氧化降解方法,对于修复因地下储油罐泄漏引起的土壤污染具有广阔的应用前景。通过室内土柱模拟柴油泄漏污染土壤,分析了不同历时残余总石油烃(total pe-troleum hydrocarbon,TPH)的平衡分布规律以及土壤中不同深度柴油量、总柴油量的变化。结果表明:(1)各柱残余TPH剖面分布差异的原因受土柱的初始装填情况的影响较大;(2)残余TPH平衡分布曲线呈双峰型的土柱,柴油的去除主要以挥发作用及生物降解作用为主;(3)挥发作用主要是由通风孔隙体积数及土壤含水率来影响的;重力作用则主要是由初始油浓度、土壤含水率、C∶N∶P影响的;除通风方式外,其余4个因素都对生物降解作用有影响;(4)初始油浓度较大,土壤含水率较小的柱8和柱11,生物降解作用最明显,柴油去除效果最好。该成果可为生物通风过程的强化提供理论依据。